-
A good friend keeps a fair bit of stainless oddments - so I was able to fine some 19.5mm I.D. / 22.5mm O.D. tube - not a fantastically common size? Anyway, perfect for the bearing spacers on my front wheels, which use a 3/4" or 19.05mm axle spindle. These spacers are sometimes called "crush tubes" but you do not crush them. They are necessary to ensure that the bearings do not suffer a lateral stress from tightening the spindle nut, which would otherwise break or wear them in a very short time. I just turned off square ends at 82.5mm long, to suit my 16" Pit bike wheels - just a bees tit longer than the gap between the bearing bosses in the hub.
Might make some further progress on my flyscreen today, too.
Simon
Have fun!
Post is under moderationStream item published successfully. Item will now be visible on your stream.
Aussie Cyclekarts acknowledges the Traditional Custodians of country and their connections to land, sea and community.
We pay respect to Elders past and present and extend that respect to all Aboriginal and Torres Strait Islander peoples today.
The Cyclekart Club of Australia Incorporated